IPv6 Tunnel

From ITCwiki
Revision as of 21:22, 8 May 2011 by JDO2010 (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

There are many different ways to connect to an IPv6 network. One of the more popular ways has been to setup an IPv6 tunnel. I have listed a few methods to set one up. Keep in mind that there are many more ways to connect to an IPv6 tunnel than the ones I have listed.

  • Windows
    • Terado
      • Go to hurricane electric's website (www.tunnelbroker.net) and register a new account and create a new tunnel.
      • Click on the "Example Configurations" tab and select your version of Windows.
      • Copy and paste the commands into your command prompt. You might need to be running the command prompt as administrator.
    • Gogo6
      • Sign up for a Freenet6 account at http://gogonet.gogo6.com/page/freenet6-ipv6-services.
      • Download the latest version of gogoCLIENT and install it.
      • Inside the utility, click on the "Advanced" tab and select "IPv6-in-UDP-IPv4 Tunnel (NAT Traversal)". This will allow you to connect from almost anywhere.
      • Go back to the "Basic" tab and select "Connect Using the Following Credentials"
      • Enter in your user name and password.
      • Click connect and select "Save" if a window pops up.
  • Cisco IOS
    • Hurricane Electric
      • Example Configuration
        • configure terminal
        • interface Tunnel0
        • description Hurricane Electric IPv6 Tunnel Broker
        • no ip address
        • ipv6 enable
        • ipv6 address 2001:470:1f10:ec5::2/64
        • tunnel source 24.131.132.166
        • tunnel destination 209.51.181.2
        • tunnel mode ipv6ip
        • ipv6 route ::/0 Tunnel0
        • end
        • write