Cisco Switch Documentation: Difference between revisions

From ITCwiki
Jump to navigation Jump to search
No edit summary
Line 14: Line 14:


=HP v1910 / 3Com Switches=
=HP v1910 / 3Com Switches=
==Enable Command Line Mode==
By default these switches are only configurable through the web interface and a very basic CLI mode. A full featured CLI mode can be enabled by connecting to the switch via Telnet or console cable and, after logging on, entering '''_cmdline-mode on'''. Confirm that all commands will be displayed and executed. You will be put in user-view mode and can enter system-view mode by typing '''system-view'''. Using the '''?''' mark you can learn about the commands available in either mode.

Revision as of 05:45, 3 February 2013

This page includes links to relevant articles on this and other sites related to switches.

Password Recovery

Authentication

Configuration

Clearing Configurations

  • switch# erase startup-config This will delete startup configurations if they were saved.
  • switch# delete flash:vlan.dat This deletes the vlan configuration.
  • switch# reload This must be done last to reload the default configurations.

HP v1910 / 3Com Switches