Cisco Shortcut Guide: Difference between revisions

From ITCwiki
Jump to navigation Jump to search
Line 64: Line 64:


== Assign Addresses ==
== Assign Addresses ==
{|border="1" cellpadding="5" cellspacing="0" align="left"
|Router#'''configuration terminal'''
Router(config)#'''interface fastethernet 0/0'''
Router(config-if)#'''ip address 192.168.1.1 255.255.255.0'''
Router(config-if)#'''no shutdown'''
Router(config-if)#'''interface serial 0/0/0'''
Router(config-if)#'''ip address 192.168.2.1 255.255.255.0'''
Router(config-if)#'''clock rate 64000'''
Router(config-if)#'''end'''
Router#show ip interfaces brief
|Router(config)#'''int f0/0'''
Router(config-if)#'''ip add 192.168.1.1 255.255.255.0'''
Router(config-if)#'''no sh'''
Router(config-if)#'''int s0/0/0'''
Router(config-if)#'''ip add 192.168.2.1 255.255.255.0'''
Router(config-if)#'''cl r 64000'''
Router(config-if)#do sh ip int bri
|}

Revision as of 19:06, 13 April 2012

Basic Tips

  • Use the up arrow to bring up your last entered commands and the down arrow to go back.


  • Type ? to see the list of possible commands and your current prompt


  • Use the home key on your keyboard to bring your cursor to the beginning of the command you're typing. You can use the end key to go back to the end.


Do you want to get out of a long list without having to scroll through everything? (For example show run)

  • Instead of hitting the space bar repeatedly just type the letter q


Are you in a config mode and wish to issue a show command?

  • Just put the word do in front of your command
    • Router(config)#do show run


  • Do the following to keep those pesky log messages from disrupting your typing:
    • Router(config)#line con 0
    • Router(config-line)#logg syn


  • Hit the tab key to automatically complete a command you are typing.


  • To quickly cancel a ping use Ctrl-Shift-6



The following examples will have the full versions of the commands next to the shortest versions.

Clear the Configurations

Switch>enable

Switch#erase startup-config

Switch#delete flash:vlan.dat (This step only needed for switches that have vlans added)

Switch#reload

Switch>en

Switch#er s

Switch#del vlan.dat

Switch#rel






Assign Addresses

Router#configuration terminal

Router(config)#interface fastethernet 0/0

Router(config-if)#ip address 192.168.1.1 255.255.255.0

Router(config-if)#no shutdown

Router(config-if)#interface serial 0/0/0

Router(config-if)#ip address 192.168.2.1 255.255.255.0

Router(config-if)#clock rate 64000

Router(config-if)#end

Router#show ip interfaces brief

Router(config)#int f0/0

Router(config-if)#ip add 192.168.1.1 255.255.255.0

Router(config-if)#no sh

Router(config-if)#int s0/0/0

Router(config-if)#ip add 192.168.2.1 255.255.255.0

Router(config-if)#cl r 64000

Router(config-if)#do sh ip int bri