LinksysRouterSetUp

How to Set Up and Secure the Linksys WRT300N Wireless N Router *

by Stefanie Mayer

(the very first thing you should always do with any electrical trouble shooting is check the power.)

First things first, go ahead and verify that you have internet connectivity, assuming that the computer has a network interface card (NIC). (Ethernet adapter)
You won't be able to connect to the internet without it.
Use a direct line (cable) to connect the modem to the computer.

Once connection is established, plug the router into an AC power outlet.
Connect the modem into the Internet port on the router (blue)
Connect the computer to any of the remaining 4 Ethernet ports (yellow)
- These are labeled and color-coded on the back of the router so if you are not sure, check.
When setting up a wireless router for the first time, the connection and setup must be prepared hardwired first. Once the setup is complete, you should be able to connect wireless.
Make sure that the computer is set to receive automatic addressing
- Start button -> Network Connections, right click Local Area Connection, -> Properties, scrolling down to the Internet Protocol (TCP/IP), -> properties, and on the General tab, select, obtain an IP address automatically.

The routers LEDs are located on the front panel and the following should be lit:
The Power LED
- NOTE: If the Power LED is blinking, you need to upgrade the router’s firmware.
WLAN or Wireless LED. If this is not lit, reset the router.
The Ethernet LED that the computer is plugged in to, either 1, 2, 3, or 4.
The Internet or WAN LED
We will check the security LED later

If this does not work, you will need to do a factory reset on the router. You can do this by pressing in the reset button for 30 seconds and then unplugging the power cord. When you power back up, the blank user name and password "admin" should get you in to the web-based Setup page.

Click the Setup tab -> Basic Setup and make sure you're set to Automatic Configuration – DHCP. Save Settings.
Now go to the Wireless tab-> Wireless Security and in the Security Mode: chose WPA Personal
In the WPA Shared Key space, enter a secure password. (Be sure to write it down, as you will need this to connect other computers to the router.) Save Settings.

SSID is associated with the 802.11 wireless LAN
Go to the Wireless tab -> Basic Wireless Settings
Here you can change the name of you router as it appears on the network or, if you want it to show or not.
On the Network Name (SSID)

Go to the Administration tab -> Management
- Here, you can change the router's password for further protection

YOU HAVE JUST SET UP A SECURE ROUTER CONNECTION!

If you have any problems during this set up you can refer to the manufacturers website [1]

->NOTE:This project is set up for use without the router’s setup CD