Resetting Switch Configuration Including VLAN Configuration Files

From ITCwiki
Jump to navigation Jump to search

Resetting Switch Configuration Including VLAN Configuration Files

To reset a switch to factory default settings use the erase statup-config or write erase command. These commands will not clear config-register or boot system settings. Boot system parameters are modified by using the boot command.

Note: If you don't have access to priveleged EXEC mode you must use the Recover Cisco Catalyst 2960 Switch Password process first.


1. Enter the write erase command from priveleged EXEC mode.

Cat2950# write erase
Erasing the nvram filesystem will remove all files! Continue? [confirm]y[OK]
Erase of nvram: complete

2. Reload the switch by entering the reload command.

Cat2950# reload
System configuration has been modified. Save? [yes/no]: n    
!--- Do not save the configuration at this prompt. Otherwise, the switch
!--- reloads with the current running configuration and does not reset to default.
Proceed with reload? [confirm]y

When the reload is complete the switch has been reset to factory defaults except for the VLAN configuration.


Reset VLAN Configuration

1. Use the show VLAN command to verify the VLAN Information.

 Cat2950# show vlan
VLAN Name                             Status    Ports
---- -------------------------------- --------- -------------------------------
1    default                          active    Fa0/1, Fa0/2, Fa0/3, Fa0/4
                                                Fa0/5, Fa0/6, Fa0/7, Fa0/8
                                                Fa0/9, Fa0/10, Fa0/11, Fa0/12
                                                Fa0/13, Fa0/14, Fa0/15, Fa0/16
                                                Fa0/17, Fa0/18, Fa0/19, Fa0/20
                                                Fa0/21, Fa0/22, Fa0/23, Fa0/24
2    VLAN0002                         active    
3    VLAN0003                         active    
4    VLAN0004                         active
       

!--- Despite the erase of the startup configuration file, !--- these user-created VLANs remain.


600  VLAN0600                         active    
1002 fddi-default                     active    
1003 token-ring-default               active    
1004 fddinet-default                  active    
1005 trnet-default                    active    
VLAN Type  SAID       MTU   Parent RingNo BridgeNo Stp  BrdgMode Trans1 Trans2
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
1    enet  100001     1500  -      -      -        -    -        1002   1003
2    enet  100002     1500  -      -      -        -    -        0      0   
3    enet  100003     1500  -      -      -        -    -        0      0   
4    enet  100004     1500  -      -      -        -    -        0      0   
600  enet  100600     1500  -      -      -        -    -        0      0   
1002 fddi  101002     1500  -      -      -        -    -        1      1003
1003 tr    101003     1500  1005   -      -        -    srb      1      1002
1004 fdnet 101004     1500  -      -      1        ibm  -        0      0   
1005 trnet 101005     1500  -      -      1        IBM  -        0      0